The Best Way to glue Background in the corners: instructions, gluing outer, inner corner, docking

Step by step directions to gluing inner corners

After completing, the main problem can be irregular walls and the resulting folds on the background. It is also crucial to take into account that when the walls are crooked, the joints of wallpaper canvases can invisibly.

After gluing the previous one in the front of the inner corner of the cloth must measure the remaining distance. It is measured from the border of the pasted cloth to the adjoining wall, and the resulting figure is inserted 10-15 millimeters. If the partitions are very curved, then the extra figure may be more.

Cut a strip equivalent to the resultant figure, taking into account the allowance. The surfaces have been treated with adhesive. Depending on the type of coat it can be just the wall or both surfaces.

The strip is glued individually with the cut side to the wall. The wallpaper should go on the opposite plane.

If the glued background is wrinkled, you will need to make a few tiny cuts perpendicular to the folds.

Level or slope on the adjacent wall is a vertical line. The distance in the corner is equal to the diameter of the previous cut strip, never adding developments.

The surfaces are smeared with glue, and the coat is glued to the wall using the flat side towards the marked line. The cut goes onto the adjacent wall.

Protruding corner should be glued by analogy with the interior, however there are small gaps, which also need to be taken into account when working.

Measured the distance remaining in the glued background to the adjacent wall. Add 20-25 millimeters to the obtained figure.

A segment is cut off, taking into account the added 20-25 millimeters.

Prior to gluing, the surfaces have been treated with adhesive.

The even edge must be glued to the wallpaper already fixed on the walls, your own cut side”extends” into the adjoining plane. If necessary, small cuts are made in the area of going to another wallpaper, smoothed and pushed into the wallsocket.

Draw gidpola.ru a vertical strip onto the adjacent wall at a distance of just glued cut strip and 6-10 millimeters.

After applying the adhesive, the strip is placed on the wall using its flat side into the marked line, going over the border of the already glued strip.

The joints are smeared with glue and ironed using a rollercoaster. Following that, the upper layer is cut along the ruler and the 2 layers are joined together.